I'
I'm sure someone else has probably had this error at some time or another, so I'm hoping someone has an answer. In my event log, every time I send a netmail (usually to my host) as soon as I enter the message it attempts to send and I always get a message: BINKPOLL BinkP got fatal error 'Bad password' from remote:
I have gone through my setup several times and cannot figure ut where the issue is. When BINKPOLL runs at a scheduled time, the message goes out like it is supposed to. So where is the error that is causing it not to go out when I enter it?
I'm sure someone else has probably had this error at some time or
another, so I'm hoping someone has an answer. In my event log,
every time I send a netmail (usually to my host) as soon as I enter
the message it attempts to send and I always get a message:
BINKPOLL BinkP got fatal error 'Bad password' from remote: I have
gone through my setup several times and cannot figure ut where the
issue is.
When BINKPOLL runs at a scheduled time, the message goes
out like it is supposed to. So where is the error that is causing
it not to go out when I enter it?
Sounds like you have a wrong session password configured somewhere.
Sounds like you have a wrong session password configured somewhere.
This seems to be the case, but why would binkpoll succeed but not binkout?
Re: Event log errorThe only linked node I have set up is with Al (1:153/757), so there really shouldn't be a problem there
By: Al to Digital Man on Sun Jul 18 2021 09:03 pm
Sounds like you have a wrong session password configured somewhere.
This seems to be the case, but why would binkpoll succeed but not binkout?
The BinkPoll event will attempt to connect to all the linked-nodes you have configured in your sbbsecho.ini with
BinkPoll=true while the BinkOut event will only connect to nodes where there is pending outbound files for it/them.
--
digital man
Synchronet/BBS Terminology Definition #20:
DCE = Data Communications Equipment (or Deuce, Stephen Hurd)
Norco, CA WX: 89.9øF, 35.0% humidity, 5 mph E wind, 0.00 inches rain/24hrs
This seems to be the case, but why would binkpoll succeed but not binkout?
The BinkPoll event will attempt to connect to all the linked-nodes you have configured in your sbbsecho.ini with BinkPoll=true while the BinkOut event will only connect to nodes where there is pending outbound files for it/them. --
The only linked node I have set up is with Al (1:153/757), so there really shouldn't be a problem there
Sysop: | Rempala |
---|---|
Location: | Richlands, NC |
Users: | 109 |
Nodes: | 10 (0 / 10) |
Uptime: | 146:32:11 |
Calls: | 331 |
Files: | 6 |
Messages: | 110,851 |